Uwell Caliburn Explorer Pod Kit

Description

Uwell Caliburn Explorer Pod Kit – 1000mAh | Max 32W | Dual-Chamber TPD Pod

The Uwell Caliburn Explorer is a refillable pod system built around a dual-chamber cartridge design and a removable coil platform (CALIBURN G / CALIBURN G2 coils). It uses an internal 1000mAh battery with regulated output up to 32W and operates primarily via auto-draw inhalation.

Mode selection is handled through a four-leaf clover control button (left / right / up / down) that switches which coil is active (left coil, right coil, dual coil, or alternate mode). The TPD pod version used in Ireland is 2ml total capacity (1ml per side).

Quick Technical Summary

Activation: Auto-draw (inhale activated)
Battery: 1000mAh internal
Power Output: Maximum 32W (regulated; mode-dependent)
Charging: USB-C (Type-C), 5V/2A
Charging Speed: 2A fast charging supported (with certified 5V/2A adapter)
Pod Capacity: 2ml total (1ml per cartridge side) – EU TPD version
Included Resistances: 0.8Ω CALIBURN G UN2 Meshed + 1.2Ω CALIBURN G2 UN2 Meshed (plus spares)
Static Wick Saturation Time: 10 minutes (after first fill)

What’s in the Box

1 × Uwell Caliburn Explorer Device (1000mAh)
1 × Dual-Chamber Refillable Pod (TPD: 2ml total / 1ml per side)
1 × 0.8Ω CALIBURN G UN2 Meshed Coil (pre-installed)
1 × 1.2Ω CALIBURN G2 UN2 Meshed Coil (pre-installed)
1 × Spare 0.8Ω CALIBURN G UN2 Meshed Coil
1 × Spare 1.2Ω CALIBURN G2 UN2 Meshed Coil
1 × USB-C (Type-C) charging cable
1 × User Manual
1 × Warranty card (if supplied)

Box contents may vary by batch.

Heating Element Status

Heating Element: Removable Coil Architecture (CALIBURN G / CALIBURN G2 coil platform)

Activation & Control

Auto-draw: Supported (draw to vape)
Power on/off: Press any single button 5 times quickly
Mode control: Four-leaf clover button selects active coil mode:
- Left Coil Mode: press Left
- Right Coil Mode: press Right
- Dual Coil Mode: press Up (both coils active)
- Alternate Mode: press Down (automatic switching between coils)
Indicators: Left / Right LED indicators + vibration prompts (status & protection)
Airflow behaviour: Pod orientation changes airflow (rotate pod for different draw feel)

Static Wick Saturation Time

Static Wick Saturation Time: 10 minutes after first fill (mandatory to reduce risk of coil burning).

Pod Filling Protocol – Dual Side Refill

The pod is split into Cartridge A and Cartridge B, each with its own filler plug.
Open the filler plug for Cartridge A, fill slowly, then reseal the plug immediately.
Repeat the same process for Cartridge B.
After filling, insert the pod and wait the full 10 minutes before first use.

This dual side refill design enables either two separate flavours (one per side) or a single flavour split across both sides, depending on user preference and selected mode.

E-Liquid Compatibility Guidance

0.8Ω Coil (MTL / Loose MTL):

✔ Optimal: 50/50 VG/PG
✔ Acceptable: up to 60VG/40PG
⚠ 70VG may be too viscous in low temperatures and may require longer saturation time

1.2Ω Coil (MTL, higher restriction):

✔ Recommended: 50/50 Nic Salts or 50/50 freebase
⚠ High VG is not recommended, especially below 10°C

Viscosity note (Ireland): VG thickens in colder conditions. Below 10°C, extend saturation time and expect slower wicking. Dual Coil Mode increases liquid demand; 50/50 is the most stable pairing for consistent saturation.

Hardware Specification Matrix

Component	Technical Specification	User Action Required	Compliance Notes
Battery	1000mAh internal cell	Charge using certified 5V/2A adapter; avoid high-voltage phone fast-charge modes	WEEE disposal applies (electrical device)
Output regulation	Maximum 32W (regulated; coil/mode dependent)	Select mode (Left / Right / Dual / Alternate) based on coil pairing and liquid viscosity	Mode-based operation (no manual wattage value stated in manual)
Pod capacity (EU TPD)	2ml total (1ml per cartridge side)	Fill both sides via separate plugs; do not overfill; reseal plugs immediately	TPD-compliant capacity for Ireland/EU
Dual side refill	Separate filler plugs for Cartridge A and B	Match flavour/strength to each side; confirm which side is active via LED indication	User-controlled dual-flavour architecture
Coil platform	FeCrAl UN2 Meshed 0.8Ω (CALIBURN G) + FeCrAl UN2 Meshed 1.2Ω (CALIBURN G2)	After coil change: refill, then wait full saturation time before vaping	Removable coil system (replacement coils sold separately)
Indicators & protection	Left/right LEDs + battery colour status + vibration prompts	Use LED status to confirm active coil side and monitor battery level before extended use	Protection indications described in user manual

Safety Features

Short-circuit protection
Low voltage protection
Overheat protection
Over 8-second vaping cut-off
Open-circuit protection (no pod/coil situation)

Charging Guidance

Charging uses USB-C (Type-C). The device supports 2A fast charging when used with a certified 5V/2A power adapter and a suitable USB-C cable. Avoid high-voltage smartphone fast-charge protocols (e.g., 9V/12V PD modes) and use stable 5V output sources only.

Cold Climate Guidance – Ireland

Below 10°C: add +2 minutes to saturation time and expect slower wicking with higher VG liquids
Below 5°C: do not leave the device in a vehicle overnight (cold soak increases viscosity and reduces wicking speed)
If the pod feels “dry” after being outdoors: allow it to warm to room temperature before use

Regulatory Stability – Ireland

Intended for adult users (18+) in Ireland
EU TPD pod capacity: 2ml total (1ml per side) for the Irish/EU version
Electrical device: dispose via WEEE collection routes where applicable
Batch-specific manufacturing variance may apply (contents and minor hardware revisions)

FAQ

Does the Caliburn Explorer support auto-draw?

Yes. The device is inhale activated (auto-draw). Draw to vape once the device is powered on.

How do I switch between left, right, dual, and alternate mode?

Use the four-leaf clover control: press Left for left coil, Right for right coil, Up for dual coil mode, and Down for alternate mode.

How long should I wait after filling for the first time?

Wait 10 minutes after the first fill to allow full wick saturation and reduce the risk of coil burning.

Does it support fast charging?

Yes. The device supports 5V/2A charging when used with a certified 5V/2A power adapter and a suitable USB-C cable.

Compatibility Last Verified: Coil platform and TPD pod capacity verified against manufacturer specifications and the CALIBURN Explorer user manual for the EU TPD configuration.

Technical Synergy: The dual-chamber pod architecture pairs with left/right/dual/alternate modes to control how coils are used, while 50/50 e-liquid viscosity provides the most stable wicking behaviour across modes—especially in Dual Coil Mode and in lower Irish temperatures.

Document Update Notice:
This product description was last reviewed and updated on 16 February 2026.