Uwell Caliburn G3 Pod 25W Vape Kit
Regular price:
product unavailable
Description
Caliburn G3 by Uwell – Technical Overview (900mAh | 25W Pod System)
The Uwell Caliburn G3 is a refillable pod system powered by a 900mAh internal battery with adjustable output up to 25W. The device operates using integrated coil pods and does not support separate coil replacement.
The EU TPD configuration features a 2ml refillable side-fill cartridge with leak-resistant silicone stopper and USB-C charging.
Technical Overview
- Activation: Auto-draw + Fire button
- Trigger Modes: Auto-draw / Button / Dual mode
- Battery: 900mAh internal
- Power Output: 5W–25W adjustable
- Charging: USB-C, 5V/2A
- Pod Capacity: 2ml (EU TPD)
- Included Pods: 0.6Ω + 0.9Ω integrated pods
- Recommended Saturation Time: 5 minutes (first fill)
System Design
Caliburn G3 features adjustable wattage up to 25W and an OLED display showing battery level, wattage and resistance. The device supports three activation configurations and includes adjustable airflow for MTL and restricted DL use. Coils are integrated into the pod and are not replaceable separately.
Activation & Control
- Auto-draw supported
- Fire button supported
- 5-click power on/off
- Selectable trigger modes:
- Auto-draw only
- Button only
- Dual activation
- Adjustable wattage (5W–25W)
- OLED display
- Airflow slider adjustment
Pod Filling Protocol – Side-Fill (EU Version)
- Remove pod from device
- Lift side silicone stopper
- Insert nozzle into side fill port
- Avoid central airflow chimney
- Reseat stopper firmly
- Allow approximately 5 minutes for initial wick saturation
E-Liquid Compatibility
0.6Ω Integrated Pod (RDL)
- ✔ Optimal: 60–70VG
- ✔ Acceptable: 50/50 VG/PG
- ⚠ High PG liquids may feel warmer at higher wattage
0.9Ω Integrated Pod (MTL)
- ✔ Recommended: 50/50 VG/PG nicotine salts or freebase
- ⚠ High VG liquids may reduce wicking efficiency
Viscosity Note (Ireland): Below 10°C VG thickens and may extend wicking time. In colder environments, slightly reduce wattage if dry sensation occurs.
Hardware Specification Matrix
| Component | Specification | User Guidance | Compliance Context |
|---|---|---|---|
| Battery | 900mAh internal cell | Charge via 5V/2A USB-C | Subject to WEEE recycling |
| Output | 5W–25W adjustable | Match wattage to pod resistance | Regulated chipset |
| Pod Architecture | Integrated coil pod (0.6Ω / 0.9Ω) | Replace full pod when flavour declines | Not compatible with G/G2 coils |
| Filling System | Side-fill via silicone stopper | Remove pod before filling | Leak-resistant design |
| Trigger Modes | 3 selectable configurations | Select preferred mode | User controlled |
Compatibility
Compatible exclusively with Uwell Caliburn G3 integrated pods. Not compatible with Caliburn G or Caliburn G2 coils or pods.
Safety Features
- Short-circuit protection
- Low voltage protection
- Overheat protection
- 8-second cut-off
- Open circuit detection
Regulatory Context – Ireland
- Intended for adult users (18+)
- 2ml EU TPD-compliant refillable pod
- Electronic device subject to WEEE recycling
FAQ
Are Caliburn G or G2 coils compatible with G3?
No. Caliburn G3 uses integrated coil pods and is not compatible with Caliburn G or G2 coils or pods.
Can I disable the fire button?
Yes. The G3 allows selection between auto-draw only, button only, or dual activation modes.
Document Update Notice:
This product description was last reviewed and updated on 26 February 2026.